Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ref:tools117 [2018/05/22 18:48] hippysmack [Countershaft] |
techtalk:ref:tools117 [2018/05/22 18:53] hippysmack [Countershaft Low Gear Bushing Installation] |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| |{{techtalk:ref:tools:mainshaft_press_by_sc72.jpg?direct&300|}}| | |{{techtalk:ref:tools:mainshaft_press_by_sc72.jpg?direct&300|}}| | ||
| - | |Mainshaft Bearing Press ((photo by sc72 http://xlforum.net/forums/showthread.php?t=1717592&highlight=engine+sprocket&page=16))| | + | ^Mainshaft Bearing Press ((photo by sc72 http://xlforum.net/forums/showthread.php?t=1717592&highlight=engine+sprocket&page=16))^ |
| ====== Countershaft ====== | ====== Countershaft ====== | ||
| Line 18: | Line 18: | ||
| * Found out the hard way not to hand ream this bushing after fitting. Set it up in a lathe and bore it true with a steel ring to hold the gear in the lathe. \\ The 17 tooth gear won't sit in a three jaw chuck evenly. ((Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) | * Found out the hard way not to hand ream this bushing after fitting. Set it up in a lathe and bore it true with a steel ring to hold the gear in the lathe. \\ The 17 tooth gear won't sit in a three jaw chuck evenly. ((Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586)) | ||
| - | |Countershaft low gear bushing jig for use in a 3 jaw chuck lathe ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586))|A pair of sockets and a 3/8" bolt for extraction, \\ a stepped collar on a 9/16 bolt to install. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586))| | ||
| |{{techtalk:ref:tools:first_gear_bushing_installation_tool_1_by_hopper.jpg?direct&400|}}|{{techtalk:ref:tools:bushing_installation_tool_by_hopper.jpg?direct&400|}}| | |{{techtalk:ref:tools:first_gear_bushing_installation_tool_1_by_hopper.jpg?direct&400|}}|{{techtalk:ref:tools:bushing_installation_tool_by_hopper.jpg?direct&400|}}| | ||
| + | ^Countershaft low gear bushing jig for use in a 3 jaw chuck lathe ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586))^A pair of sockets and a 3/8" bolt for extraction, \\ a stepped collar on a 9/16 bolt to install. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586))^ | ||
