Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:tools124 [2019/01/24 16:43] hippysmack [Rocker Arms] |
techtalk:ref:tools124 [2019/08/17 15:26] hippysmack [Evo Engine] |
||
---|---|---|---|
Line 13: | Line 13: | ||
^ A little cutting, a little welding and you have a special wrench to reach the bolts under the frame. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=2)) ^^ | ^ A little cutting, a little welding and you have a special wrench to reach the bolts under the frame. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=2)) ^^ | ||
====== Evo Engine ====== | ====== Evo Engine ====== | ||
+ | Cutting down Allen wrenches to make them shorter on the end will allow you to get into tight places easier. \\ | ||
+ | It also helps when the ends get rounded which allows the tool to slip in the socket head. \\ | ||
+ | Using a Dremil tool or a file on the end can get rid of the round and help to keep it from slipping. \\ | ||
|{{techtalk:ref:tools:cut_down_allen_1_wrenches_by_hippysmack.jpg?direct&400|}}|{{techtalk:ref:tools:cut_down_allen_3_wrenches_by_hippysmack.jpg?direct&400|}}| | |{{techtalk:ref:tools:cut_down_allen_1_wrenches_by_hippysmack.jpg?direct&400|}}|{{techtalk:ref:tools:cut_down_allen_3_wrenches_by_hippysmack.jpg?direct&400|}}| | ||
- | ^ Allen wrench end cut shorter with a Dremil cut-off blade ((photos by Hippysmack)) ^^ | + | ^ Allen wrench end cut shorter with a Dremil cut-off blade ((photos by Hippysmack)) ^^ |
+ | |||
+ | You can also use a 1/4" ratcheting wrench with 1/4" attachments (cheap attachments are easy to replace). \\ | ||
+ | Makes hard to get at Allen heads such as the speedo sender and the rear left rocker cover bolts easy to remove/replace. \\ | ||
+ | This is a 'Snap On Blue Point' brand 1/4" and 5/16" offset/reversible wrench ($32 delivered). \\ | ||
+ | |||
+ | |{{:techtalk:ref:tools:offset_wrench_by_aussiegazza.png?direct&300|}}| | ||
+ | ^ Offset wrench for rocker box cover. ((photo by AussieGazza of the XLFORUM http://xlforum.net/forums/showthread.php?postid=1181033)) ^ | ||
====== Rocker Arms ====== | ====== Rocker Arms ====== |