Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:tools125 [2018/05/21 07:57] ixl2relax [REF: Tools - Sub-025] |
techtalk:ref:tools125 [2020/06/22 01:55] hippysmack [IH Cylinder Base Nut] |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| |{{techtalk:ref:tools:cylinder_base_nut_crowsfoot_by_hopper.jpg?direct&400|}}| | |{{techtalk:ref:tools:cylinder_base_nut_crowsfoot_by_hopper.jpg?direct&400|}}| | ||
| |Crows foot for the 9/16" base nut. \\ If you grind down a crows foot like this, it works quite well, ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586))| | |Crows foot for the 9/16" base nut. \\ If you grind down a crows foot like this, it works quite well, ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586))| | ||
| + | |||
| + | ====== Measuring Cylinder Bore ====== | ||
| + | |||
| + | |{{:techtalk:ref:tools:measuring_cylinder_1_by_horseman1.jpg?direct&300|}}|{{:techtalk:ref:tools:measuring_cylinder_2_by_horseman1.jpg?direct&300|}}| | ||
| + | ^ Telescoping bore gauge and caliper for measuring cylinder I/D. ((phoros by Horseman1 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1943121&page=7)) ^^ | ||
| + | |||
| + | ====== Boring / Honing ====== | ||
| + | |||
| + | |{{:techtalk:ref:tools:torque_plates_by_spamer80.jpg?direct&200|}}|{{:techtalk:ref:tools:lisle_cylinder_hone_by_hippysmack.jpg?direct&400|}}| | ||
| + | ^Torque plates. ((photo by spamer80 of the XLFORUM http://xlforum.net/forums/showthread.php?t=2070501&page=16))^ Lisle 15000 Cylinder Hone ((photo by Hippysmack)) ^ | ||
