Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
techtalk:ref:tools131 [2020/05/28 19:11] hippysmack [Sprocket Holding Tool] |
techtalk:ref:tools131 [2022/09/25 02:42] ixl2relax [Sprocket Holding Tool] |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| ====== Sprocket Nut Removal ====== | ====== Sprocket Nut Removal ====== | ||
| - | + | Transmission sprocket nut for rigid XLs should all be the same wrench size: 1-7/8" (47.625mm) . \\ | |
| - | {{:techtalk:ref:tools:impact_wrench_by_anachris.jpg?direct&250|}} ((photo by AnaChris of the XLFORUM http://xlforum.net/forums/showthread.php?t=1725973&highlight=oil+pump&page=20)) \\ | + | It's a 6 point nut and will require a 6 point socket to remove / install. \\ |
| + | Normally, the sprocket holding tool below is used to keep the sprocket from turning while removing the nut. \\ | ||
| + | |||
| + | {{:techtalk:ref:tools:transmission_sprocket_removal_with_impact_wrench_by_anachris.jpg?direct&300|}} ((photo by AnaChris of the XLFORUM http://xlforum.net/forums/showthread.php?t=1725973&highlight=oil+pump&page=20)) {{:techtalk:ref:tools:transmission_sprocket_nut_size_1998_1200s_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
| ====== Sprocket Holding Tool ====== | ====== Sprocket Holding Tool ====== | ||
| Line 15: | Line 18: | ||
| {{:techtalk:ref:tools:trans_sprocket_holding_tool_by_anachris.jpg?direct&300|}} ((photo by AnaChris of the XLFORUM http://xlforum.net/forums/showthread.php?t=1725973&highlight=oil+pump&page=30)) \\ | {{:techtalk:ref:tools:trans_sprocket_holding_tool_by_anachris.jpg?direct&300|}} ((photo by AnaChris of the XLFORUM http://xlforum.net/forums/showthread.php?t=1725973&highlight=oil+pump&page=30)) \\ | ||
| + | |||
| + | DIY by Graywolf of the XLForum - See thread here: http://xlforum.net/forums/showthread.php?t=1806002 | ||
| + | |||
| + | {{:techtalk:ref:tools:trans-finaldrivesprocket-tool-graywolf.jpg?400|}}((photo by Graywolf of the XLForum http://xlforum.net/forums/showthread.php?t=1806002)) | ||
| ===== Fabricated Sprocket Nut Wrench ===== | ===== Fabricated Sprocket Nut Wrench ===== | ||
