Table of Contents
This is an old revision of the document!
REF: Tools - 131
Trans Final Drive Sprocket Tools
Sprocket Nut Removal
Transmission sprocket nut for rigid XLs should all be the same wrench size: 1-7/8“ (47.625mm) .
It's a 6 point nut and will require a 6 point socket to remove / install.
Normally, the sprocket holding tool below is used to keep the sprocket from turning while removing the nut.
Sprocket Holding Tool
Final drive locking tool from J&Pcycles.com part # (910-576).
Don't forget to buy a longer grade 8 bolt to use as a stop for the tool.
Just pick the hole your going to use and but one from an auto parts or hardware store.
DIY by Graywolf of the XLForum - See thread here: http://xlforum.net/forums/showthread.php?t=1806002
Fabricated Sprocket Nut Wrench
1)
photo by AnaChris of the XLFORUM http://xlforum.net/forums/showthread.php?t=1725973&highlight=oil+pump&page=20
2)
photo by Hippysmack
3)
photo by AnaChris of the XLFORUM http://xlforum.net/forums/showthread.php?t=1725973&highlight=oil+pump&page=30
4)
photo by Graywolf of the XLForum http://xlforum.net/forums/showthread.php?t=1806002
5)
, 6)
, 7)
photos by KRTT Clone of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=5