This is an old revision of the document!
REF: Tools - 132
Shop Press
Can be made from whatever you find at the scrap yard, this was made from steel channel bolted to the 2x4s. Then, a couple pieces of steel bolted to the bottom of the bottle jack (one with a hole in the center of the jack to hold a 3/8“ socket drive to which I can attach whatever size socket or adapter needed to press on a bearing). Then under that is another piece of steel to spread the load a bit 1) |
|
Homemade Shop Press 2) |
---|
1)
billeuze of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=6
2)
photos by billeuze of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=6