Differences
This shows you the differences between two versions of the page.
techtalk:ref:tools146 [2018/07/27 01:52] hippysmack created |
techtalk:ref:tools146 [2024/01/24 21:49] (current) hippysmack |
||
---|---|---|---|
Line 3: | Line 3: | ||
====== General Engine Electrical, Sensors, etc. ====== | ====== General Engine Electrical, Sensors, etc. ====== | ||
===== O2 Sensor ===== | ===== O2 Sensor ===== | ||
- | An open end 7/8" wrench or crescent wrench will be sufficient to remove / install the O2 sensor. ((Charles: of the XLFORUM http://xlforum.net/forums/showthread.php?t=853778&page=2)) \\ | + | An open end 7/8" wrench or crescent wrench will be sufficient to remove / install the O2 sensor. ((Charles: of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-intake-and-exhaust/sportster-motorcycle-air-intake-carburetor-efi-fuel-and-exhaust/99610-02-sensor-removal-tool/page2?t=853778&page=2)) \\ |
However, the tools below will make it a little easier. | However, the tools below will make it a little easier. | ||
- | |||
|{{:techtalk:ref:tools:o2_sensor_tool_by_biknut.jpg?direct&300|}}|{{:techtalk:ref:tools:o2_sensor_socket_1_by_rocketmangb.jpg?direct&300|}}|{{:techtalk:ref:tools:o2_sensor_socket_2_by_rocketmangb.jpg?direct&300|}}| | |{{:techtalk:ref:tools:o2_sensor_tool_by_biknut.jpg?direct&300|}}|{{:techtalk:ref:tools:o2_sensor_socket_1_by_rocketmangb.jpg?direct&300|}}|{{:techtalk:ref:tools:o2_sensor_socket_2_by_rocketmangb.jpg?direct&300|}}| | ||
- | | Box end 7/8" with a section cut out to clear the wire. ((photo by biknut of the XLFORUM http://xlforum.net/forums/showthread.php?t=853778))| 7/8" deep well 6 point socket with a side milled out to clear the wire ((photo by rocketmangb of the XLFORUM http://xlforum.net/forums/showthread.php?t=853778)) || | + | | Box end 7/8" with a section cut out to clear the wire. ((photo by biknut of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-intake-and-exhaust/sportster-motorcycle-air-intake-carburetor-efi-fuel-and-exhaust/99610-02-sensor-removal-tool?t=853778))| 7/8" deep well 6 point socket with a side milled out to clear the wire ((photo by rocketmangb of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-intake-and-exhaust/sportster-motorcycle-air-intake-carburetor-efi-fuel-and-exhaust/99610-02-sensor-removal-tool?t=853778)) || |
\\ | \\ |