[[:techtalk:menu|{{  :techtalk:gototechnicalmenu.jpg|}}]]
====== REF: Tools - 146 ======
====== General Engine Electrical, Sensors, etc. ======
===== O2 Sensor =====
An open end 7/8" wrench or crescent wrench will be sufficient to remove / install the O2 sensor. ((Charles: of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-intake-and-exhaust/sportster-motorcycle-air-intake-carburetor-efi-fuel-and-exhaust/99610-02-sensor-removal-tool/page2?t=853778&page=2)) \\ 
However, the tools below will make it a little easier.

|{{:techtalk:ref:tools:o2_sensor_tool_by_biknut.jpg?direct&300|}}|{{:techtalk:ref:tools:o2_sensor_socket_1_by_rocketmangb.jpg?direct&300|}}|{{:techtalk:ref:tools:o2_sensor_socket_2_by_rocketmangb.jpg?direct&300|}}|
| Box end 7/8" with a section cut out to clear the wire. ((photo by biknut of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-intake-and-exhaust/sportster-motorcycle-air-intake-carburetor-efi-fuel-and-exhaust/99610-02-sensor-removal-tool?t=853778))|  7/8" deep well 6 point socket with a side milled out to clear the wire ((photo by rocketmangb of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-intake-and-exhaust/sportster-motorcycle-air-intake-carburetor-efi-fuel-and-exhaust/99610-02-sensor-removal-tool?t=853778))  ||

\\

[[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]]