Differences

This shows you the differences between two versions of the page.

Link to this comparison view

techtalk:ref:tools146 [2018/07/27 01:52] (current)
hippysmack created
Line 1: Line 1:
 +[[:​techtalk:​menu|{{ ​ :​techtalk:​gototechnicalmenu.jpg|}}]]
 +====== REF: Tools - 146 ======
 +====== General Engine Electrical, Sensors, etc. ======
 +===== O2 Sensor =====
 +An open end 7/8" wrench or crescent wrench will be sufficient to remove / install the O2 sensor. ((Charles: of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=853778&​page=2)) \\ 
 +However, the tools below will make it a little easier.
 +
 +
 +|{{:​techtalk:​ref:​tools:​o2_sensor_tool_by_biknut.jpg?​direct&​300|}}|{{:​techtalk:​ref:​tools:​o2_sensor_socket_1_by_rocketmangb.jpg?​direct&​300|}}|{{:​techtalk:​ref:​tools:​o2_sensor_socket_2_by_rocketmangb.jpg?​direct&​300|}}|
 +| Box end 7/8" with a section cut out to clear the wire. ((photo by biknut of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=853778))| ​ 7/8" deep well 6 point socket with a side milled out to clear the wire ((photo by rocketmangb of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=853778)) ​ ||
 +
 +\\
 +
 +[[:​techtalk:​menu|{{:​techtalk:​gototechnicalmenu.jpg|}}]]