Table of Contents
This is an old revision of the document!
REF: Tools - 146
General Engine Electrical, Sensors, etc.
O2 Sensor
An open end 7/8“ wrench or crescent wrench will be sufficient to remove / install the O2 sensor. 1)
However, the tools below will make it a little easier.
Box end 7/8” with a section cut out to clear the wire. 2) | 7/8“ deep well 6 point socket with a side milled out to clear the wire 3) |
1)
Charles: of the XLFORUM http://xlforum.net/forums/showthread.php?t=853778&page=2
2)
photo by biknut of the XLFORUM http://xlforum.net/forums/showthread.php?t=853778
3)
photo by rocketmangb of the XLFORUM http://xlforum.net/forums/showthread.php?t=853778