Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:tools151 [2018/11/06 22:21] hippysmack [Pin Vise] |
techtalk:ref:tools151 [2019/02/17 23:02] hippysmack [Left Hand Drill Bit] |
||
---|---|---|---|
Line 16: | Line 16: | ||
^Left Hand Drill Bit ((photo by Graywolf of the XLFORUM http://xlforum.net/forums/showthread.php?page=3&t=1836654))^ | ^Left Hand Drill Bit ((photo by Graywolf of the XLFORUM http://xlforum.net/forums/showthread.php?page=3&t=1836654))^ | ||
+ | ====== Pilot Point Drill Bit ====== | ||
+ | These bits have a built in 'center bore' on the end. \\ | ||
+ | It cuts center first and the fluted cutter comes in to cut the primary hole. \\ | ||
+ | This helps to keep the bit from wandering and keep the hole centered throughout the cut. \\ | ||
+ | |||
+ | |{{:techtalk:ref:tools:3-16_pilot_drill_bit_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:3-16_pilot_drill_bit_2_by_hippysmack.jpg?direct&300|}}| | ||
====== Pin Vise ====== | ====== Pin Vise ====== | ||
A pin vise is made for holding tiny drill bits. \\ | A pin vise is made for holding tiny drill bits. \\ |