Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
techtalk:ref:tools159 [2019/09/12 04:12] hippysmack [Multimeter (VOM)] |
techtalk:ref:tools159 [2020/06/21 21:51] hippysmack [Multimeter (VOM)] |
||
---|---|---|---|
Line 31: | Line 31: | ||
* The values may move a little, but generally they will fluctuate around a meaningful value if the contact point is solid. | * The values may move a little, but generally they will fluctuate around a meaningful value if the contact point is solid. | ||
- | | See also [[techtalk:ref:svcproc30#reftroubleshooting_-_07|Testing an oil pressure switch]] | | + | | See also [[techtalk:ref:svcproc30#reftroubleshooting_-_07|Testing an oil pressure switch]] | When checking ohms, first check that the meter \\ reads '0' ohms with leads pressed together. ((photo by Hippysmack)) | |
- | |{{techtalk:ref:svcproc:testing_the_oil_pressure_switch_7_by_hippysmack.jpg?direct&300|}}| | + | |{{techtalk:ref:svcproc:testing_the_oil_pressure_switch_7_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:multimeter_on_ohms_scale.jpg?direct&300|}}| |
+ | ====== Probe Mod ====== | ||
+ | |||
+ | You can buy a couple alligator clips from an auto parts / electronic store and gently crimp the ends over the end of the straight probes. \\ | ||
+ | This will allow you to clip onto pinouts for testing. \\ | ||
+ | You can also lightly wrap electrical tape over the assembly for working in areas where the pins are close to each other so they don't make contact. \\ | ||
+ | |||
+ | {{:techtalk:ref:tools:multimeter_probe_mod_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:multimeter_probe_mod_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
\\ | \\ |