Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
techtalk:ref:tools159 [2019/11/09 18:28] hippysmack [Multimeter (VOM)] |
techtalk:ref:tools159 [2020/06/21 21:51] hippysmack [Multimeter (VOM)] |
||
|---|---|---|---|
| Line 34: | Line 34: | ||
| |{{techtalk:ref:svcproc:testing_the_oil_pressure_switch_7_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:multimeter_on_ohms_scale.jpg?direct&300|}}| | |{{techtalk:ref:svcproc:testing_the_oil_pressure_switch_7_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:multimeter_on_ohms_scale.jpg?direct&300|}}| | ||
| + | ====== Probe Mod ====== | ||
| + | |||
| + | You can buy a couple alligator clips from an auto parts / electronic store and gently crimp the ends over the end of the straight probes. \\ | ||
| + | This will allow you to clip onto pinouts for testing. \\ | ||
| + | You can also lightly wrap electrical tape over the assembly for working in areas where the pins are close to each other so they don't make contact. \\ | ||
| + | |||
| + | {{:techtalk:ref:tools:multimeter_probe_mod_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:multimeter_probe_mod_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
| \\ | \\ | ||
