Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
techtalk:ref:tools159 [2019/09/12 04:12] hippysmack [Multimeter (VOM)] |
techtalk:ref:tools159 [2024/01/24 22:39] (current) hippysmack |
||
---|---|---|---|
Line 17: | Line 17: | ||
- | Multimeters are extremely useful and are pretty hardy. ((sifty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1592463&page=42)) \\ | + | Multimeters are extremely useful and are pretty hardy. ((sifty of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/146604-first-harley-1975-xl1000-caf%C3%A9-project/page42?t=1592463&page=42)) \\ |
But using the wrong setting, wrong scale, or performing the wrong type of measurement will at best give meaningless results, and at worst smoke the meter. \\ | But using the wrong setting, wrong scale, or performing the wrong type of measurement will at best give meaningless results, and at worst smoke the meter. \\ | ||
Line 31: | Line 31: | ||
* The values may move a little, but generally they will fluctuate around a meaningful value if the contact point is solid. | * The values may move a little, but generally they will fluctuate around a meaningful value if the contact point is solid. | ||
- | | See also [[techtalk:ref:svcproc30#reftroubleshooting_-_07|Testing an oil pressure switch]] | | + | | See also [[techtalk:ref:svcproc30#reftroubleshooting_-_07|Testing an oil pressure switch]] | When checking ohms, first check that the meter \\ reads '0' ohms with leads pressed together. ((photo by Hippysmack)) | |
- | |{{techtalk:ref:svcproc:testing_the_oil_pressure_switch_7_by_hippysmack.jpg?direct&300|}}| | + | |{{techtalk:ref:svcproc:testing_the_oil_pressure_switch_7_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:multimeter_on_ohms_scale.jpg?direct&300|}}| |
+ | ====== Probe Mod ====== | ||
+ | |||
+ | You can buy a couple alligator clips from an auto parts / electronic store and gently crimp the ends over the end of the straight probes. \\ | ||
+ | This will allow you to clip onto pinouts for testing. \\ | ||
+ | You can also lightly wrap electrical tape over the assembly for working in areas where the pins are close to each other so they don't make contact. \\ | ||
+ | |||
+ | {{:techtalk:ref:tools:multimeter_probe_mod_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:multimeter_probe_mod_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
\\ | \\ |