Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:tools167 [2019/08/02 00:24] hippysmack [Exhaust Tools] |
techtalk:ref:tools167 [2020/03/01 04:06] hippysmack [Jims #788 Exhaust Seal Installation Tool] |
||
---|---|---|---|
Line 16: | Line 16: | ||
{{:techtalk:ref:tools:jims_exhaust_gasket_tool_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:jims_exhaust_gasket_tool_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | {{:techtalk:ref:tools:jims_exhaust_gasket_tool_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:jims_exhaust_gasket_tool_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
+ | |||
+ | ===== Homemade Exhaust Gasket Installer ===== | ||
+ | |||
+ | You can toss the gaskets into the freezer for about a half hour to shrink them up a little before installing them. \\ | ||
+ | A good hour or two works better but that still may not help much. \\ | ||
+ | Then, carefully tap them into place with a 2x4 piece of wood and a hammer. \\ | ||
+ | Try not to fold them over while seating them into the counterbore. | ||
+ | |||
+ | 2x2 piece of wood used below... could have had better results with a 2x4. \\ | ||
+ | {{:techtalk:ref:tools:installing_exhaust_gaskets_2_by_johnk.jpg?direct&300|}} ((photo by JohnK of the XLFORUM http://xlforum.net/forums/showthread.php?p=3944070)) {{:techtalk:ref:tools:installing_exhaust_gaskets_1_by_johnk.jpg?direct&300|}} ((photo by JohnK of the XLFORUM http://xlforum.net/forums/showthread.php?p=3944070)) \\ | ||
\\ | \\ |