Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ref:tools167 [2019/08/02 00:24] hippysmack [Exhaust Tools] |
techtalk:ref:tools167 [2020/08/11 04:16] hippysmack [Jims #788 Exhaust Seal Installation Tool] |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ====== Exhaust Tools ====== | ====== Exhaust Tools ====== | ||
| ===== Jims #788 Exhaust Seal Installation Tool ===== | ===== Jims #788 Exhaust Seal Installation Tool ===== | ||
| - | See the installation PDF here: [[http://www.jimsusa.com/pdf/instruction-sheets/788-IS.pdf]] \\ | + | |
| For use on all 1984 to present Evo Big Twin, XL, and Twin Cam models. \\ | For use on all 1984 to present Evo Big Twin, XL, and Twin Cam models. \\ | ||
| This tool installs the exhaust pipe seal H-D No. 65324-83B or Screamin’ Eagle No.17048-98 or equivalent exhaust gaslets. \\ | This tool installs the exhaust pipe seal H-D No. 65324-83B or Screamin’ Eagle No.17048-98 or equivalent exhaust gaslets. \\ | ||
| Line 16: | Line 16: | ||
| {{:techtalk:ref:tools:jims_exhaust_gasket_tool_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:jims_exhaust_gasket_tool_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | {{:techtalk:ref:tools:jims_exhaust_gasket_tool_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:jims_exhaust_gasket_tool_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
| + | |||
| + | ===== Homemade Exhaust Gasket Installer ===== | ||
| + | |||
| + | You can toss the gaskets into the freezer for about a half hour to shrink them up a little before installing them. \\ | ||
| + | A good hour or two works better but that still may not help much. \\ | ||
| + | Then, carefully tap them into place with a 2x4 piece of wood and a hammer. \\ | ||
| + | Try not to fold them over while seating them into the counterbore. | ||
| + | |||
| + | 2x2 piece of wood used below... could have had better results with a 2x4. \\ | ||
| + | {{:techtalk:ref:tools:installing_exhaust_gaskets_2_by_johnk.jpg?direct&300|}} ((photo by JohnK of the XLFORUM http://xlforum.net/forums/showthread.php?p=3944070)) {{:techtalk:ref:tools:installing_exhaust_gaskets_1_by_johnk.jpg?direct&300|}} ((photo by JohnK of the XLFORUM http://xlforum.net/forums/showthread.php?p=3944070)) \\ | ||
| \\ | \\ | ||
