Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
techtalk:ref:tools167 [2020/03/01 04:06] hippysmack [Jims #788 Exhaust Seal Installation Tool] |
techtalk:ref:tools167 [2021/03/31 22:25] ixl2relax [Jims #788 Exhaust Seal Installation Tool] |
||
---|---|---|---|
Line 3: | Line 3: | ||
====== Exhaust Tools ====== | ====== Exhaust Tools ====== | ||
===== Jims #788 Exhaust Seal Installation Tool ===== | ===== Jims #788 Exhaust Seal Installation Tool ===== | ||
- | See the installation PDF here: [[http://www.jimsusa.com/pdf/instruction-sheets/788-IS.pdf]] \\ | + | |
- | For use on all 1984 to present Evo Big Twin, XL, and Twin Cam models. \\ | + | For use on all 1984 to present Evo Big Twin, XL, and Twin Cam models. ([[techtalk:evo:carb04|See the Sportsterpedia EVO Exhaust Section]])\\ |
- | This tool installs the exhaust pipe seal H-D No. 65324-83B or Screamin’ Eagle No.17048-98 or equivalent exhaust gaslets. \\ | + | This tool installs the exhaust pipe seal H-D No. 65324-83B or Screamin’ Eagle No.17048-98 or equivalent exhaust gaskets. \\ |
It will position the gasket evenly into the head exhaust port thus preventing exhaust leaks. \\ | It will position the gasket evenly into the head exhaust port thus preventing exhaust leaks. \\ | ||
Line 15: | Line 15: | ||
- Using Jims tool handle (33416-80) -sold separately- install the small end into the center hole of 788 plate with a new seal in position. \\ Place these pieces up to the head and onto the exhaust mounting studs. \\ Then use a mallet to lightly tap on the end of the handle until the tool plate seats in the head. \\ Then install the pipes up to the head per the FSM. | - Using Jims tool handle (33416-80) -sold separately- install the small end into the center hole of 788 plate with a new seal in position. \\ Place these pieces up to the head and onto the exhaust mounting studs. \\ Then use a mallet to lightly tap on the end of the handle until the tool plate seats in the head. \\ Then install the pipes up to the head per the FSM. | ||
- | {{:techtalk:ref:tools:jims_exhaust_gasket_tool_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:jims_exhaust_gasket_tool_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | + | {{:techtalk:ref:tools:jims_exhaust_gasket_tool_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:ref:tools:jims_exhaust_gasket_tool_3_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ |
===== Homemade Exhaust Gasket Installer ===== | ===== Homemade Exhaust Gasket Installer ===== |