Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ref:tools168 [2019/09/11 04:50] hippysmack created |
techtalk:ref:tools168 [2019/09/11 05:20] hippysmack [Uses] |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ====== REF: Tools - 167 ====== | ====== REF: Tools - 167 ====== | ||
| ====== Dremil Type Rotary Tool ====== | ====== Dremil Type Rotary Tool ====== | ||
| + | A Dremil tool has many uses from cutting to polishing metal. Always wear a face shield when using this tool. \\ | ||
| + | It operates at a very high speed and tiny pieces of the cutting bits and the metal will hit your eyes faster than you can blink. \\ | ||
| + | It's good for cutting carbon & stainless steel, shortening bolts, shaping metal projects etc. \\ | ||
| + | |||
| + | {{:techtalk:ref:tools:dremel_tool_by_graywolf.jpg?direct&300|}} ((photo by Graywolf of the XLFORUM http://xlforum.net/forums/showthread.php?t=2070881&page=3)) \\ | ||
| + | |||
| + | ====== Uses ====== | ||
| + | |||
| + | |Cutting slots in pipes for shields. ((photo by Graywolf of the XLFORUM http://xlforum.net/forums/showthread.php?t=2070881&page=3))| Shortening a bolt. ((photos by Hippysmack)) || | ||
| + | |{{:techtalk:ref:tools:heatshield_strap_by_graywolf.jpg?direct&300|}}|{{:techtalk:ref:tools:shortening_a_bolt_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:tools:shortening_a_bolt_2_by_hippysmack.jpg?direct&300|}}| | ||
| + | | | ||
| + | |||
| + | |||
| \\ | \\ | ||
