Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
techtalk:ref:tools168 [2019/09/11 05:20]
hippysmack [Uses]
techtalk:ref:tools168 [2019/11/10 14:59]
hippysmack
Line 1: Line 1:
 [[:​techtalk:​menu|{{ ​ :​techtalk:​gototechnicalmenu.jpg|}}]] [[:​techtalk:​menu|{{ ​ :​techtalk:​gototechnicalmenu.jpg|}}]]
-====== REF: Tools - 167 ======+====== REF: Tools - 168 ======
 ====== Dremil Type Rotary Tool ====== ====== Dremil Type Rotary Tool ======
 A Dremil tool has many uses from cutting to polishing metal. Always wear a face shield when using this tool. \\ A Dremil tool has many uses from cutting to polishing metal. Always wear a face shield when using this tool. \\
Line 10: Line 10:
 ====== Uses ====== ====== Uses ======
  
-|Cutting slots in pipes for shields. ((photo by Graywolf of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=2070881&​page=3))| ​ Shortening a bolt. ((photos by Hippysmack)) ​ || +|Cutting slots in pipes for shields. ((photo by Graywolf of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=2070881&​page=3))|  
-|{{:​techtalk:​ref:​tools:​heatshield_strap_by_graywolf.jpg?​direct&​300|}}|{{:​techtalk:​ref:​tools:​shortening_a_bolt_1_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​tools:​shortening_a_bolt_2_by_hippysmack.jpg?​direct&​300|}}|+|{{:​techtalk:​ref:​tools:​heatshield_strap_by_graywolf.jpg?​direct&​300|}}| 
 + 
 +Usually, cutting the end off a bolt requires sanding / filing the cut area to deburr / chamfer the end. \\ 
 +However, the Dremil tool cuts at a high speed with a thin cutting disc. \\ 
 +Keep the cutting blade perpendicular to the threads while cutting and, most of the time, deburring the cut end is optional or at least minimal. \\ 
 +There is no need to install a nut and back it off the threads as you would normally do when using a hack saw or grinder. \\ 
 + 
 +|  Shortening a bolt. ((photos by Hippysmack))  ​||| 
 +|{{:​techtalk:​ref:​tools:​shortening_a_bolt_1_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​tools:​shortening_a_bolt_2_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​tools:​shortening_a_bolt_3_by_hippysmack.jpg?​direct&​300|}}|
 | |