REF: Gears, Sprockets, Belts - Sub-01A

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

[[:techtalk:menu|{{  :techtalk:gototechnicalmenu.jpg|}}]]
====== REF: Gears, Sprockets, Belts - Sub-01A ======
\\
====== Installing Chain-to-Belt Conversion ======
\\

This conversion information provided by 'dave76' of the XLForum - http://xlforum.net/forums/showthread.php?t=2082025

I finally found time to finish this project on my 1990 1200 XLH Sportster. I took it for a ride afterwards (it was freezing weather - but I enjoyed it). The belt is definitely quieter and smoother than the chain configuration.

{{:techtalk:ref:transfinal:dave76-cn-blt-02.jpg?600|image1}}

===== Parts =====

I found multiple used rear pulleys on eBay under $50. I got a used but perfect 128 tooth belt for $65.\\
I got the belt guard for $35. Only bought a new VTwin front pulley for $85.\\
{{:techtalk:ref:transfinal:dave76-cn-blt-03.jpg?400|image1}}

Top: Belt guard ---------- Bottom: 4 speed chain guard\\
{{:techtalk:ref:transfinal:dave76-cn-blt-04.jpg?400|image1}}

A standard 1991 Belt Drive Sprocket Cover will be needed, the left middle bolt is no longer used so I just used a short faux bolt and nut.

The Belt I used was 1-1/8" wide with 128 teeth. This puts the axle adjuster in the middle of the range.

**The main part numbers that I was able to find were:**

40271-89 -- Front drive pulley 27 tooth

40258-89 -- Rear driven pulley (pulley only not the chrome guide cover).

40273-89 -- Rear pulley chrome guide cover.

I cannot find the number for the top or bottom belt guards.
I sourced my rear pulley off eBay, the front came from V-Twin (Taiwan teddy).

40022-91 -- Drive Belt (Standard Harley 1-1/8 x 128 teeth).

===== Details =====

{{:techtalk:ref:transfinal:dave76-cn-blt-01.jpg?400|image1}}

I bought the counterbore from eBay. This is needed to sink one of the case bolts about 3/16 of an inch to provide better belt clearance.\\
{{:techtalk:ref:transfinal:dave76-cn-blt-05.jpg?600|image1}}\\
\\
{{:techtalk:ref:transfinal:dave76-cn-blt-06.jpg?400|image1}}

To clear the new belt drive sprocket, I used a 1991-up Drive Sprocket Cover. On the engine, the top rear stand-off stud (near the motor mount) needs to removed. It is replaced with a 7/16-14 x 2” bolt. The unused (open) hole in the sprocket cover just gets a faux bolt and nut.\\
{{:techtalk:ref:transfinal:dave76-cn-blt-07.jpg?400|image1}}



\\
[[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]]

Trace: • W E L C O M E ! • REF: Gears, Sprockets, Belts - Sub-01A • REF: Extra Models • IH: Engine Mechanicals - Sub-03E • REF: Engine Mechanicals - Sub-01M • REF: Tools - 157 • EVO: Engine Control - Sub-03b