REF: Engine Mechanicals

Bottom End

You can buy different brands but this is basically a slide hammer with an expandable collet.

Blind Hole Bearing Puller (Harbor Freight model) ¹⁾

Decrease the width of the collet ²⁾	Install it into and behind the bushing ³⁾	Tighten the nuts to expand the collet ⁴⁾

Hold outward pressure on the handle. Then yank the bushings out by knocking the slide against the handle end of the tool ⁵⁾

The collet isn't wide enough to damage the case on the way out ⁶⁾	However, the chamfer inside the collet will damage the bushing (L). Compare to new bushing on the right. ⁷⁾

¹⁾ , ²⁾ , ³⁾ , ⁴⁾ , ⁶⁾ , ⁷⁾

photo by Hippysmack

⁵⁾

photos by Hippysmack