Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
techtalk:evo:engmech04p [2025/10/01 07:35] – [Valve Train Geometry] hippysmacktechtalk:evo:engmech04p [2025/10/10 00:25] (current) – [Checking Lifter Pre-load] hippysmack
Line 39: Line 39:
 The lifter plunger should be preloaded between .050 and .150. Make the measurement if you're not sure. \\ The lifter plunger should be preloaded between .050 and .150. Make the measurement if you're not sure. \\
 {{:techtalk:evo:engmech:checking_lifter_preload_by_aswracing.jpg?direct&300|}} ((photo by aswracing of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-motor-engine/sportster-motorcycle-motor-top-end/42637-push-rod-length?t=113818)) \\ {{:techtalk:evo:engmech:checking_lifter_preload_by_aswracing.jpg?direct&300|}} ((photo by aswracing of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-motor-engine/sportster-motorcycle-motor-top-end/42637-push-rod-length?t=113818)) \\
- 
- 
  
 Pushrod lean angle on 91-up engines. Pushrod lean angle on 91-up engines.

Trace: