Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
techtalk:ih:engmech03e [2017/12/20 03:34] hippysmack [Three angle valve seats - FLT/FL/FX/XL models] |
techtalk:ih:engmech03e [2018/01/21 15:16] (current) hippysmack [Three angle valve seats - FLT/FL/FX/XL models] |
||
---|---|---|---|
Line 4: | Line 4: | ||
- | * The MoCo issued a bulletin in June of 1980 stating that all 1980 production models incorporate three angle valve seats on the (intake and exhaust) ports on the heads. ((HD Service Bulletin #M-782 dated June 3, 1980)) | + | * The MoCo issued a bulletin in June of 1980 stating that all 1980 production models incorporate three angle valve seats on the (intake and exhaust) ports on the new -80 heads. ((HD Service Bulletin #M-782 dated June 3, 1980)) |
- | * In April of 1981, this was reiterated for XL Models starting with cracnkcase (781012001). ((HD Service Bulletin #M-827 dated April 24, 1981)) | + | * In April of 1981, this was reiterated for XL Models starting with crankcase (781012001) with the introduction of new heads for the 81 model year, ((HD Service Bulletin #M-827 dated April 24, 1981)) which were available as replacement for previous year models. |
* There are specific procedures that must be followed when cutting this type of valve seat. Always be sure to reface the valves before you cut the seats. A Neway Valve Seat Cutter (444-HDF) or other quality equipment is recommended for this. | * There are specific procedures that must be followed when cutting this type of valve seat. Always be sure to reface the valves before you cut the seats. A Neway Valve Seat Cutter (444-HDF) or other quality equipment is recommended for this. | ||
* Follow the procedures outlined in the service manual for removing and re-facing valves and guides and decarbonizing the combustion chamber. | * Follow the procedures outlined in the service manual for removing and re-facing valves and guides and decarbonizing the combustion chamber. |