Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ih:engmech09h [2021/06/28 23:41] hippysmack [Rear Mount Assembly] |
techtalk:ih:engmech09h [2021/06/28 23:44] hippysmack [Rear Mount Assembly] |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| All the bolts must pass through the mount with no binding or pulling. Shim the top 2 bolts if you have to. \\ | All the bolts must pass through the mount with no binding or pulling. Shim the top 2 bolts if you have to. \\ | ||
| Or file the bolt holes slightly to allow the mount to sit in place naturally. \\ | Or file the bolt holes slightly to allow the mount to sit in place naturally. \\ | ||
| + | Chase the threads with a tap if needed so you get no binding when turning a bolt in a hole by hand. \\ | ||
| Snug the bolts down gradually to allow the mount to shift as needed as bolts are tightened. \\ | Snug the bolts down gradually to allow the mount to shift as needed as bolts are tightened. \\ | ||
| Do not try to adjust the rear mount so the motor will fit in the frame. Adjust the frame instead (it is most likely the problem). | Do not try to adjust the rear mount so the motor will fit in the frame. Adjust the frame instead (it is most likely the problem). | ||
