Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
techtalk:ih:engmech09h [2021/06/28 23:41] hippysmack [Rear Mount Assembly] |
techtalk:ih:engmech09h [2023/12/31 20:22] (current) hippysmack [Rear Mount Assembly] |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ====== IH: Engine Mechanicals - Sub-09H ====== | ====== IH: Engine Mechanicals - Sub-09H ====== | ||
| ====== Rear Mount Assembly ====== | ====== Rear Mount Assembly ====== | ||
| - | The rear mount locates the motor. All other mounts bow to the rear mount. It is the king. ((ryder rick of the XLFORUM | + | The rear mount locates the motor. All other mounts bow to the rear mount. It is the king. ((ryder rick of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/109872-71-motor-mounts/page2#post3120871)) ((https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/203556-lower-frame-rail-clearance-issues#post4557070)) ((https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/198787-finally-building#post4369721)) ((https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/130889-rolling-basket-case-saga-now-it-s-the-rear-motor-mount/page3#post3120737)) \\ |
| Always always ALWAYS install all the rear mount bolts first before tightening. \\ | Always always ALWAYS install all the rear mount bolts first before tightening. \\ | ||
| Line 8: | Line 8: | ||
| All the bolts must pass through the mount with no binding or pulling. Shim the top 2 bolts if you have to. \\ | All the bolts must pass through the mount with no binding or pulling. Shim the top 2 bolts if you have to. \\ | ||
| Or file the bolt holes slightly to allow the mount to sit in place naturally. \\ | Or file the bolt holes slightly to allow the mount to sit in place naturally. \\ | ||
| + | Chase the threads with a tap if needed so you get no binding when turning a bolt in a hole by hand. \\ | ||
| Snug the bolts down gradually to allow the mount to shift as needed as bolts are tightened. \\ | Snug the bolts down gradually to allow the mount to shift as needed as bolts are tightened. \\ | ||
| Do not try to adjust the rear mount so the motor will fit in the frame. Adjust the frame instead (it is most likely the problem). | Do not try to adjust the rear mount so the motor will fit in the frame. Adjust the frame instead (it is most likely the problem). | ||
| Line 14: | Line 15: | ||
| If you have trouble with one of the bolts, remove the others and start that one first. \\ | If you have trouble with one of the bolts, remove the others and start that one first. \\ | ||
| Take your time to do it right, take the motor back out if you have to. | Take your time to do it right, take the motor back out if you have to. | ||
| - | |||
| - | |||
| \\ | \\ | ||
