Differences
This shows you the differences between two versions of the page.
| - | Both sides previous revisionPrevious revision |
| - | techtalk:ih:oil03p [2025/02/26 20:34] – [Inspect the Housing Roll Pin] hippysmack |
|---|---|
| + | |
| + | techtalk:ih:oil03p [2025/02/26 20:36] (current) – hippysmack |
| @@ Line -111,5 +111,6 @@ | |
| **The roll pin below was damaged and a second roll pin was added to keep from removing the original pin**. \\ | |
| In order to add the second pin, additional slots have to be cut into both the inner and outer plates since they are both captured by the roll pin. \\ | |
| {{: | |
| ===== Inspect the gearshaft and bushings for damage or wear ===== | |
| * Check the gearshaft teeth for pits, breakage or wear. Replace the gearshaft as necessary. \\ Also do not forget to check the teeth on the oil pump drive gear on the pinion shaft. \\ If the teeth on it are thin, replace the drive gear. \\ Pinion shaft runout can wear the drive gear teeth down thin enough to break off and float with the oil. | |
