Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:oil06 [2021/02/17 03:58] hippysmack [Diagnosing Oil Consumption] |
techtalk:ih:oil06 [2021/02/18 00:54] hippysmack [Cam Gear Oiler ('85 only)] |
||
---|---|---|---|
Line 242: | Line 242: | ||
| Pulling oil seal gently with small bicycle tire iron. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=209347&page=11)) | | | Pulling oil seal gently with small bicycle tire iron. ((photo by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=209347&page=11)) | | ||
|{{:techtalk:ih:oil:removing_cam_seal_in_cover_by_hopper.jpg?direct&300|}}| | |{{:techtalk:ih:oil:removing_cam_seal_in_cover_by_hopper.jpg?direct&300|}}| | ||
- | ===== Cam Gear Oiler ('85 only) ===== | ||
- | |||
- | Starting with crankcase number 785 303 002, manufactured after October 29, 1984, a cam gear oiler was installed in the gearcase ceiling. ((HD TSB #M-899 dated November 30, 1984)) \\ | ||
- | The cam gear oiler directs oil from the top end oil passage to the gear mesh between first and second gears and third and fourth gears. \\ | ||
- | Direct lubrication of the gear teeth allows tighter gear fitment. Gear backlash and noise are reduced. \\ | ||
- | |||
- | * The oiler tube has restricted orifices to spray the gears and still retain main oil feed pressure from whence the oil came (top oil feed galley). | ||
- | * There is an O-ring on the oiler tube nipple that is pressed into the ceiling of the gearcase. | ||
- | * If the O-ring fails to seal the oiler tube, feed oil pressure to the top end could be low. \\ You probably wouldn't see a leak as it would be inside the gearcase. | ||
- | |||
- | |||
- | |Cam oiler tube hole in gearcase. ((photo by Iron Mike of the XLFORUM, labeled by Hippysmack http://xlforum.net/forums/showthread.php?t=1750617&page=116)) | Cam gear oiler installed. ((photo by iNSaNeSHaNe of the XLFORUM http://xlforum.net/forums/showthread.php?t=1750617&page=122)) | | ||
- | |{{:techtalk:ih:engmech:1985_cam_gear_oiler_gearcase_by_iron_mike.jpg?direct&300|}}|{{:techtalk:ih:engmech:1985_cam_gear_oiler_by_insaneshane.jpg?direct&300|}}| | ||
===== Breather Vent / Tube ===== | ===== Breather Vent / Tube ===== |