Differences

This shows you the differences between two versions of the page.

Link to this comparison view

-Both sides previous revisionPrevious revision
-techtalk:ih:wheels01a [2018/04/18 01:18]
– ixl2relax
+
+techtalk:ih:wheels01a [2024/01/02 16:43] (current)
– hippysmack
@@ Line -4,6 +4,5 @@ removed created
 
 ==== Problems Associated with Drum Brake Rear Hubs ====
 Article by Dr Dick of the XLFORUM ((httphttps://www.xlforum.net/forumsforum/showthread.phpsportster-motorcycle-forum/sportster-motorcycle-era-specific-and-model-specific/ironhead-sportster-motorcycle-talk-1957-1985/140736-rear-hub-thread?t=1525902)) 
 
   * The problems associated with drum brake rear hubs depends on your definition of what a problem is to you. If you have reoccurring problems with wheel bearing failure, brake performance or chain life, this info maybe helpful in tracking down the cause. 
@@ Line -12,5 +11,4 @@ removed created
     * All models used the same single row bearing on left side.
   * All bearings referred to below are the right side.
 
 
 **1952-1954 ↓ models:**   
@@ Line -22,5 +20,4 @@ removed created
 
 **1955-E1958 ↓ models:**
 
 
     * Used the 1st symmetric flange hub.
@@ Line -29,5 +26,4 @@ removed created
 
 **L1958-1962 ↓ models:**
 
 
     * Same hub as previously used.
@@ Line -37,5 +33,4 @@ removed created
 
 **1963-1965 ↓ models:**
 
 
     * Same hub as previous.
@@ Line -44,5 +39,4 @@ removed created
 
 **1966-1972 ↓ models:**
 
 
     * The brake side hub flange was made thicker at the bolt mounting area.
@@ Line -51,5 +45,4 @@ removed created
 
 **1973-1978 ↓ models:**
 
 
     * Some time between 1973 & 1975, brazing got replaced by welded construction.

Trace: