Table of Contents
This is an old revision of the document!
I
ID
Abbreviation for Inside Diameter
Ignition Advance
Condition of increasing the timing of the spark plug firing at higher engine RPMs
Ignition System (Battery Ignition)
(1959-1978) Component chain: battery-ignition switch- ignition coil- condenser- breaker points (cam action activated) 1)
Ignition System (Breakerless)
(1979) Upgrade to the breaker point system in which the mechanical points are replaced by an electronic ignition on the camshaft. Timer has a rotor with one small lobe and one large lobe and a sensor that sends signal to the control module on the back of the timer inner cover. Rotor is mounted on a mechanical flywheel centrifugal advance like a point cam would be in a breaker point system. The rotor's small lobe fires the front cylinder and the large lobe fires the rear cylinder. 2)
Ignition System (Electronic)
(1980 on) Components include a timing rotor/(timing cup), sensor plate or inductive pickup, ignition control module, ignition coil and spark plugs. Full electronic advance, inductive pickup generates pulses that are sent to the solid state Ignition Control Module (ICM). The ICM computes ignition timing advance/ coil dwell. In 1983, a Vacuum Operated Electric Switch (VOES) was added to switch between 2 different spark advance curves. 3)
Ignition System (Magneto)
(1959-1968) Components include an induction coil, rotor, condenser, circuit breaker and a circuit breaker cam. 4)
- (1959-1964) Magneto is mounted in a fixed position producing advanced spark timing only
- (1965-1968) Magneto is mounted on a movable plate allowing for spark timing retard also
The magneto is controlled manually by turning the left handlebar grip.
Ignition Timing
The moment at which the spark plug fires as expressed in the number of crankshaft degrees before the piston reaches TDC
Infinity
An open circuit. Zero continuity in an electrical path
ILSAC
International Lubricants Standardization and Approval Committee, was formed in 1992 by AAMA (American Automobile Manufacturers Association, representatives of DaimlerChrysler Corporation, Ford Motor Company and General Motors Corporation) and JAMA (Japan Automobile Manufacturers Association) to define the need, parameters, licensing and administration of lubricant specifications. Together with the Tripartite system (API, SAE and ASTM) the formed EOLCS, the Engine Oil Licensing and Certification System. ILSAC oils often carry the API Service Symbol (Donut) including the Energy Conserving designation and/or API Certification Mark (Starburst). 129)