Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
techtalk:ref:elec09 [2017/10/24 17:07] ixl2relax [Device Connector Pinouts] |
techtalk:ref:elec09 [2024/01/13 21:50] (current) hippysmack |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== REF: Electrical System ====== | ====== REF: Electrical System ====== | ||
- | ====== Device Connector Pinouts ====== | + | \\ |
- | ECM/ICM, Speedo, TSM/TSSM/HFSM, Etc. Connector Pinouts: | + | ====== Device Connector Pinouts (ECM/ICM/TSM/TSSM/SPEEDO/TACH/Etc) ====== |
- | ====== Device Connector Pinouts ====== | + | \\ |
+ | |||
+ | ===== 1998-2003 Sport Model - Device Connector Pinouts ===== | ||
+ | |||
+ | |||
+ | ===== 2004-2017+ Models - Device Connector Pinouts ===== | ||
+ | |||
+ | <code> | ||
+ | 2004-2006 Sportsters - ECM/TSM/Etc Connections | ||
+ | https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-electrical/sportster-motorcycle-electrical-and-ignition/174323-2004-2006-wiring-info?t=1869052 | ||
+ | |||
+ | ICM position numbers – purpose – wire color | ||
+ | 1 run/stop w/bk | ||
+ | 2 battery bn/gy | ||
+ | 3 +5 sensor power r/w | ||
+ | 4 sensor ground bk/w | ||
+ | 5 module ground bk | ||
+ | 6 coil, front be/o | ||
+ | 7 coil, rear y/be | ||
+ | 8 crank position sensor + r | ||
+ | 9 crank position sensor - bk | ||
+ | 10 vehicle speed sensor w/gn | ||
+ | 11 MAP signal v/w | ||
+ | 12 Serial Data Link lgn/v | ||
+ | |||
+ | TSM/TSSM | ||
+ | 1 battery bn/gy | ||
+ | 2 ignition gy | ||
+ | 3 Serial Data Link lgn/v | ||
+ | 4 security indicator | ||
+ | 5 left turn output v | ||
+ | 6 right turn output bn | ||
+ | 7 right turn input w/bn | ||
+ | 8 left turn input w/v | ||
+ | 9 starter relay control tn/gn | ||
+ | 10 ignition enable switch | ||
+ | 11 alarm signal lgn/bn | ||
+ | 12 ground bk | ||
+ | |||
+ | Speedo (numbers are left-right) | ||
+ | 12 blank | ||
+ | 11 trip switch bk (to 8) | ||
+ | 10 blank | ||
+ | 9 blank | ||
+ | 8 trip switch (to 11) | ||
+ | 7 ground bk | ||
+ | 6 accessory o/w | ||
+ | 5 battery bn/gy | ||
+ | 4 security bn/v | ||
+ | 3 blank | ||
+ | 2 Serial Data Link lg/v | ||
+ | 1 ignition o | ||
+ | |||
+ | Tach | ||
+ | 1 ignition o | ||
+ | 2 Serial Data Link lg/v | ||
+ | 3 blank | ||
+ | 4 blank | ||
+ | 5 battery bn/gy | ||
+ | 6 accessory o/w | ||
+ | 7 ground bk | ||
+ | 8 blank | ||
+ | 9 blank | ||
+ | 10 blank | ||
+ | 11 blank | ||
+ | 12 blank | ||
+ | |||
+ | |||
+ | |||
+ | 2007-2013 Sportsters - ECM/TSM/Etc Connections | ||
+ | https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-electrical/sportster-motorcycle-electrical-and-ignition/174324-2007-2013-wiring-info?t=1869053 | ||
+ | |||
+ | ECM position numbers – purpose – wire color | ||
+ | 1 blank | ||
+ | 2 system relay gn/o | ||
+ | 3 blank | ||
+ | 4 blank | ||
+ | 5 Serial Data Link lgn/v | ||
+ | 6 engine temperature pk/y | ||
+ | 7 intake air temp lgn/y | ||
+ | 8 front oxygen sensor (A) pk/o | ||
+ | 9 jiffy stand switch (HDI only) gn/bn | ||
+ | 10 power ground bk | ||
+ | 11 coil, rear y/be | ||
+ | 12 crank position sensor (-) bk | ||
+ | 13 switched power w/bk | ||
+ | 14 5V sensor power r/w | ||
+ | 15 blank | ||
+ | 16 blank | ||
+ | 17 idle air control (A) high bk/o | ||
+ | 18 idle air control (B) low bk/pk | ||
+ | 19 fuel injector, rear gn/gy | ||
+ | 20 blank | ||
+ | 21 fuel injector, front w/y | ||
+ | 22 blank | ||
+ | 23 rear oxygen sensor pk/gn | ||
+ | 24 throttle position sensor input gy/v | ||
+ | 25 TMAP sensor input v/w (TMAP replaced MAP in 2010) | ||
+ | 26 5V sensor ground bk/w | ||
+ | 27 blank | ||
+ | 28 power ground bk | ||
+ | 29 coil, front be/o | ||
+ | 30 crank position sensor (+) r | ||
+ | 31 battery be/gy | ||
+ | 32 blank | ||
+ | 33 vehicle speed sensor input bk/be | ||
+ | 34 blank | ||
+ | 35 idle air control (A) low be/gn | ||
+ | 36 idle air control (B) high bn/r | ||
+ | |||
+ | TSM/TSSM | ||
+ | 1 battery bn/gy | ||
+ | 2 ignition gy | ||
+ | 3 Serial Data Link lgn/v | ||
+ | 4 neutral safety switch tn (formerly security indicator on 2004-2006) | ||
+ | 5 left turn output v | ||
+ | 6 right turn output bn | ||
+ | 7 right turn input w/bn | ||
+ | 8 left turn input w/v | ||
+ | 9 starter relay control tn/gn | ||
+ | 10 clutch control bk/r (formerly ignition enable switch on 2004-2006) | ||
+ | 11 alarm signal lgn/bn | ||
+ | 12 ground bk | ||
+ | |||
+ | Speedo (numbers are left-right) | ||
+ | 12 blank | ||
+ | 11 trip switch bk (to 8) | ||
+ | 10 blank | ||
+ | 9 fuel y/w (formerly blank on 2004-2006) | ||
+ | 8 trip switch (to 11) | ||
+ | 7 ground bk | ||
+ | 6 accessory o/w | ||
+ | 5 battery bn/gy | ||
+ | 4 blank (formerly security on 2004-2006) | ||
+ | 3 blank | ||
+ | 2 Serial Data Link lg/v | ||
+ | 1 ignition o | ||
+ | |||
+ | Tach | ||
+ | 1 ignition o | ||
+ | 2 Serial Data Link lg/v | ||
+ | 3 blank | ||
+ | 4 blank | ||
+ | 5 battery bn/gy | ||
+ | 6 accessory o/w | ||
+ | 7 ground bk | ||
+ | 8 blank | ||
+ | 9 blank | ||
+ | 10 blank | ||
+ | 11 blank | ||
+ | 12 blank | ||
+ | |||
+ | |||
+ | |||
+ | 2014-later - Utilizing CANbus communications | ||
+ | https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-electrical/sportster-motorcycle-electrical-and-ignition/186702-canbus-major-connections?t=1995444 | ||
+ | |||
+ | (Thanks to schematics supplied by JauntyBishop, Sportsterdoc posted this information.) | ||
+ | |||
+ | ECM-bank one | ||
+ | 1. Rear ignition coil gray/blue | ||
+ | 2. Front ignition coil green/blue | ||
+ | 3. Front heated oxygen heater ground black/orange | ||
+ | 4. VSS input light green/yellow | ||
+ | 5. Front fuel injector green/yellow | ||
+ | 6. Rear fuel injector gray/yellow | ||
+ | 7. MAP input gray | ||
+ | 8. JSS signal light green/gray | ||
+ | 9. ION sensor light green/brown | ||
+ | 10. Sensor ground black/gray | ||
+ | 11. No position | ||
+ | 12. No position | ||
+ | 13. CAN lo white/black | ||
+ | 14. CAN hi white/red | ||
+ | 15. Rear heated oxygen heater ground black/pink | ||
+ | 16. CKP sensor hi red | ||
+ | 17. Front heated oxygen sensor green/brown | ||
+ | 18. CKP sensor lo black | ||
+ | |||
+ | ECM-bank two | ||
+ | 1. IAC A hi green/orange | ||
+ | 2. Blank | ||
+ | 3. Blank | ||
+ | 4. Blank | ||
+ | 5. Blank | ||
+ | 6. IAT green/gray | ||
+ | 7. 5v sensor ground black/white | ||
+ | 8. ET sensor green | ||
+ | 9. 5v sensor power red/white | ||
+ | 10. Sensor ground black/green | ||
+ | 11. IAC A lo gray/orange | ||
+ | 12. IAC B hi green/white | ||
+ | 13. IAC B lo gray/white | ||
+ | 14. Blank | ||
+ | 15. TPS green/violet | ||
+ | 16. System power red/green | ||
+ | 17. 17. Rear heated oxygen sensor gray/brown | ||
+ | 18. Battery fuse red/orange | ||
+ | |||
+ | BCM | ||
+ | 1. Battery power red | ||
+ | A2. Security antenna hi red | ||
+ | A3. Start enable white/brown | ||
+ | A4. Security RF antenna black | ||
+ | B2. Security antenna lo black | ||
+ | C3. Ignition switch input white/blue | ||
+ | C4. Ignition stop switch input white/gray | ||
+ | D2. CAN hi white/red | ||
+ | D3. Neutral switch input white | ||
+ | E2. CAN lo white/black | ||
+ | E3. Oil pressure switch input white/orange | ||
+ | E4. Horn power red/violet | ||
+ | F3. Brake switch input blue/green | ||
+ | F4. Fuel pump power red/brown | ||
+ | G4. Sensor ground black/green | ||
+ | H2. Security Siren white/green | ||
+ | J2. Front right turn signal blue/orange | ||
+ | J3. Running light power blue | ||
+ | J4. Front left turn signal blue/pink | ||
+ | K2. Right rear turn signal blue/brown | ||
+ | K3. Brake lamp power blue/red | ||
+ | K4. Left rear turn signal blue/violet | ||
+ | L2. Starter solenoid power red/black | ||
+ | L4. Front running/fog lights power red/green | ||
+ | M2. Accessory power red/yellow | ||
+ | M3. Hi beam power blue/white | ||
+ | M4. Low beam power blue/yellow | ||
+ | |||
+ | |||
+ | SPEEDO CONNECTIONS (in order from factory schematics) | ||
+ | 8. CAN hi white/black from ECM 13 | ||
+ | 2. CAN lo white/red from ECM 14 | ||
+ | 4. Hi beam indicator blue/white | ||
+ | 5. Battery red/orange | ||
+ | 6. Neutral indicator white | ||
+ | 7. Sensor ground black/green | ||
+ | 1. Oil pressure white/orange | ||
+ | 9. Fuel level white/yellow | ||
+ | 10. Left turn indicator blue pink | ||
+ | 12. Right turn indicator blue/orange | ||
+ | |||
+ | IGNITION SWITCH | ||
+ | white/blue from BCM C3 | ||
+ | black/green to BCM G4 | ||
+ | …involving 800 ohm and 200 ohm resistors | ||
+ | |||
+ | ANTI-THEFT Connections | ||
+ | D black/green sensor ground | ||
+ | C white/black start enable to BCM A3 | ||
+ | B blank | ||
+ | A blank | ||
+ | A red/orange power | ||
+ | B white/green signal to BCM H2 | ||
+ | C black ground | ||
+ | |||
+ | Optional - ABS ECU | ||
+ | 18 red battery power | ||
+ | 14 orange/brown rear WSS lo | ||
+ | 13 orange/pink rear WSS hi | ||
+ | 12 orange/blue front WSS hi | ||
+ | 11 white/black CAN lo | ||
+ | 10 black sensor ground | ||
+ | 9 red battery power | ||
+ | 4 blue/black switch auxillary lamp power | ||
+ | 3 orange/black front WSS lo | ||
+ | 2 white/red CAN hi | ||
+ | 1 black/green sensor ground | ||
+ | </code> | ||
+ | |||
+ | (This section contributed by Sportsterdoc) | ||