Differences

This shows you the differences between two versions of the page.

--- techtalk:ref:engctl50h [2020/01/31 08:10]
ixl2relax
+++ techtalk:ref:engctl50h [2021/06/29 12:58]
ixl2relax [Installing & Connecting to the TC88A]
@@ Line 17: / Line 17: @@
 Disconnect the 12-pin connector that plugs into the stock ignition module (under the seat). Remove the two bolts holding the OEM module in place and mount the TC88A unit in it's place.
-Using a small screwdriver, or a pick, remove the plastic plug from the face of the 12-pin main harness connector. **Remove** the BROWN/Grey wire from Pin 2 location. This is a power wire, so be sure to tape it up & shrink-wrap it well to prevent it from shorting anywhere. Using the WHITE jumper wire that comes with the tuner, feed the open ended side through the rubber plug (into Pin 2 position) until it is flush with the face of the connector. Then snap the plug back into the face.
+Using a small screwdriver, or a pick, remove the plastic plug from the face of the 12-pin main harness connector. **Remove** the BROWN/Gray wire from Pin 2 location. This is a power wire, so be sure to tape it up & shrink-wrap it well to prevent it from shorting anywhere. Using the WHITE jumper wire that comes with the tuner, feed the open ended side through the rubber plug (into Pin 2 position) until it is flush with the face of the connector. Then snap the plug back into the face.
 {{:techtalk:ref:engctl:tc88a-hd-connector1-esteid.jpg?300|Image by ESteid}}  {{:techtalk:ref:engctl:tc88a-hd-connector2-esteid.jpg?300|Image by ESteid}}  {{:techtalk:ref:engctl:tc88a-connunitharness-12pin-npaisnel.jpg?205|Image by NPaisnel}}

Trace:

Differences

Navigation

Search

Toolbox