Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:engmech01i [2018/08/12 02:41] hippysmack |
techtalk:ref:engmech01i [2018/08/12 03:16] hippysmack [Installing Inner Cam Bushings (in the gear case)] |
||
---|---|---|---|
Line 3: | Line 3: | ||
====== Installing Inner Cam Bushings (in the gear case) ====== | ====== Installing Inner Cam Bushings (in the gear case) ====== | ||
- | Per the FSM, each cam bushing installed in the gearcase must be positioned with the oiling slot at the exact top of the bore (12:00 position). ((HD XLH FSM pg 3-51)) | + | Per the FSM, each cam bushing installed in the gearcase must be positioned with the oiling slot at the exact top of the bore (12:00 position). ((HD XLH FSM pg 3-51)) \\ |
+ | |||
+ | Bushings are press fitted into the case. A press fit translates to the O.D. of the bushing being the same as the I.D. of the case bore (for practical purposes here). \\ | ||
+ | When a new bushing is pressed into the case bore, it's I.D is compressed and becomes distorted somewhat. \\ | ||
+ | The bushing is then reamed to the correct size and alignment to the cover bushings. | ||