Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:engmech07s [2020/10/05 20:51] hippysmack |
techtalk:ref:engmech07s [2020/10/07 00:12] hippysmack [XR-750 8-Ball Breather Valve] |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| The 8-ball breather was designed to handle 45 cu. in. of volume. ((mrmom9r of the XLFORUM http://xlforum.net/forums/showthread.php?t=2041173&page=3)) \\ | The 8-ball breather was designed to handle 45 cu. in. of volume. ((mrmom9r of the XLFORUM http://xlforum.net/forums/showthread.php?t=2041173&page=3)) \\ | ||
| - | Here is the breather hole in the rear of the crankcase where the 8-ball breather assembly is fitted. \\ | + | The first pic below shows the 3/4" tapped hole in the case behind the rear cylinder where the 8-ball breather assembly is fitted. \\ |
| {{:techtalk:ref:engmech:1972_xr-750_8-ball_breather_hole_in_case_by_dr_dick.jpg?direct&300|}} ((photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?p=4148222#post4148222)) {{:techtalk:ref:engmech:1972_xr-750_crankcase_breather_by_brucstoudt.jpg?direct&300|}} ((photo by brucstoudt of the XLFORUM, cropped by Hippysmack http://xlforum.net/forums/showthread.php?t=2077883)) {{:gallery:iron:1972_xr-750_by_brucstoudt.jpg?direct&300|}} ((photo by brucstoudt of the XLFORUM http://xlforum.net/forums/showthread.php?t=2077883)) \\ | {{:techtalk:ref:engmech:1972_xr-750_8-ball_breather_hole_in_case_by_dr_dick.jpg?direct&300|}} ((photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?p=4148222#post4148222)) {{:techtalk:ref:engmech:1972_xr-750_crankcase_breather_by_brucstoudt.jpg?direct&300|}} ((photo by brucstoudt of the XLFORUM, cropped by Hippysmack http://xlforum.net/forums/showthread.php?t=2077883)) {{:gallery:iron:1972_xr-750_by_brucstoudt.jpg?direct&300|}} ((photo by brucstoudt of the XLFORUM http://xlforum.net/forums/showthread.php?t=2077883)) \\ | ||
