Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ref:priclutch01 [2022/05/02 02:12] ixl2relax |
techtalk:ref:priclutch01 [2022/05/02 02:19] ixl2relax [L84-90 Models] |
||
|---|---|---|---|
| Line 70: | Line 70: | ||
| ===== L84-90 Models ===== | ===== L84-90 Models ===== | ||
| - | * Most of the above procedure applies to these models as well, although these magnets are on the Clutch Basket, not the drive gear. | + | * Most of the above procedure applies to these models as well. In this case, the rotor is part of the Clutch assembly, therefore, the magnets are inside that housing. |
| - | * With a used clutch housing with good magnets, take all the magnets out first and re-glue them with epoxy (Loctite 3455 used in the pics below). | + | * On a used clutch housing with good magnets, take all the magnets out and re-glue them with epoxy (Loctite 3455 used in the pics below). |
| |{{:techtalk:ref:priclutch:clutch_shell_magnet_fix_1_by_harton.jpg?direct&300|}} ((Photo by harton of the XLFORUM http://xlforum.net/forums/showthread.php?t=1678442))|{{:techtalk:ref:priclutch:clutch_shell_magnet_fix_2_by_harton.jpg?direct&300|}} ((Photo by harton of the XLFORUM http://xlforum.net/forums/showthread.php?t=1678442))| | |{{:techtalk:ref:priclutch:clutch_shell_magnet_fix_1_by_harton.jpg?direct&300|}} ((Photo by harton of the XLFORUM http://xlforum.net/forums/showthread.php?t=1678442))|{{:techtalk:ref:priclutch:clutch_shell_magnet_fix_2_by_harton.jpg?direct&300|}} ((Photo by harton of the XLFORUM http://xlforum.net/forums/showthread.php?t=1678442))| | ||
