Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:priclutch02 [2022/02/01 19:44] ixl2relax [Upgrade Clutch Release Bearing - HD P/N 8885 to 7200B Angular Ball Bearing] |
techtalk:ref:priclutch02 [2023/08/13 21:29] ixl2relax [Upgrade Clutch Release Bearing - HD P/N 8885 to 7200B Angular Ball Bearing] |
||
---|---|---|---|
Line 260: | Line 260: | ||
**Be sure to purchase the genuine FAG brand or another high quality bearing (as knockoff versions do not hold up).** | **Be sure to purchase the genuine FAG brand or another high quality bearing (as knockoff versions do not hold up).** | ||
- | It is important to orient the bearing in the right direction when pressing the bearing into the Release Plate. Examine the side view of the bearing below and notice that there is a wide & narrow face to both the outer bearing race and the inner bearing race. They have a sort-of L-shape. They are oppositely oriented. | + | It is important to orient the bearing in the right direction when pressing the bearing into the Release Plate. Examine the side view of the bearing below and notice that there is a wide & narrow face to both the outer bearing race and the inner bearing race. They have a sort-of L-shape. They are oriented in opposing directions to create the axial support. |
{{techtalk:ref:priclutch:clutchreleasebearing-7200b-angular-install.jpg?400|}}((Annotated by IXL2Relax at the XLForum)) {{techtalk:ref:priclutch:clutchreleasebearing-7200b-angular.jpg?400|}}((Thanks to Reddtigger - xlforum.net/forums/showthread.php?t=1688139)) | {{techtalk:ref:priclutch:clutchreleasebearing-7200b-angular-install.jpg?400|}}((Annotated by IXL2Relax at the XLForum)) {{techtalk:ref:priclutch:clutchreleasebearing-7200b-angular.jpg?400|}}((Thanks to Reddtigger - xlforum.net/forums/showthread.php?t=1688139)) | ||
Line 271: | Line 271: | ||
Additional discussion: | Additional discussion: | ||
http://xlforum.net/forums/showthread.php?t=1688139 | http://xlforum.net/forums/showthread.php?t=1688139 | ||
+ | |||
+ | XLForum member 'Bikervation' has created a [[https://youtu.be/7BFSrilNk5Q|utube video]] of replacing this bearing. In it he uses a 17mm & 30mm socket to remove the old bearing and a 22mm socket to install the new bearing. Thease are used as presses, not socket wrenches during the procedure. You will benefit from viewing the actual process. | ||
+ | |||
\\ | \\ |