Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
techtalk:ref:svcproc16 [2020/04/25 18:55] hippysmack [Assembly] |
techtalk:ref:svcproc16 [2024/01/21 21:10] (current) hippysmack [Assembly] |
||
---|---|---|---|
Line 51: | Line 51: | ||
It can be pushed down with your finger to install the clip. \\ | It can be pushed down with your finger to install the clip. \\ | ||
But with a lifter half or more full of oil, it's harder to work the plunger with your fingers as the pressure behind the plunger is greater. \\ | But with a lifter half or more full of oil, it's harder to work the plunger with your fingers as the pressure behind the plunger is greater. \\ | ||
+ | In fact, it's nearly impossible to assemble a lifter completely full of oil. \\ | ||
If you install the lifter into a holder, that frees up both hands and gives better leverage on the plunger. \\ | If you install the lifter into a holder, that frees up both hands and gives better leverage on the plunger. \\ | ||
The holder below is fabbed from a steel sheet and a welded bushing to hold the lifter. \\ | The holder below is fabbed from a steel sheet and a welded bushing to hold the lifter. \\ | ||
Line 58: | Line 59: | ||
The block is used to press the plunger down. A spare pushrod or screwdriver can also be used to depress the plunger. | The block is used to press the plunger down. A spare pushrod or screwdriver can also be used to depress the plunger. | ||
- | {{:techtalk:ref:tools:lifter_holding_tool_2_by_ngot8r.jpg?direct&300|}} ((photo by NGOT8R of the XLFORUM http://xlforum.net/forums/showthread.php?t=2076454&page=4)) | + | {{:techtalk:ref:tools:lifter_holding_tool_2_by_ngot8r.jpg?direct&300|}} ((photo by NGOT8R of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-motor-engine/sportster-motorcycle-engine-conversions/199567-converting-from-1250-to-1275/page4?t=2076454&page=4)) |
|{{:techtalk:ref:svcproc:lifter_assembly_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:svcproc:lifter_assembly_3_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:svcproc:lifter_assembly_4_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:ref:svcproc:lifter_assembly_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:svcproc:lifter_assembly_3_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:svcproc:lifter_assembly_4_by_hippysmack.jpg?direct&300|}}| |