Table of Contents
This is an old revision of the document!
REF: Shop Notes, Tips, and Tools - Sub-03P
Engine and Clutch Sprocket Locking Tools
4 Speed
Here's a very simple and easy (and free) tool to make to lock your clutch hub to remove or torque the nut. Take 2 clutch discs and 3 steels, install them into your clutch hub assembly, drill two 5/16 holes thru the old clutches and steels, and use 2 1/4 inch bolts to bolt them together. Leave the bolts just a shade loose so fitting the tool back into the hub is made easier because the parts can float around a little. Now install your 2 pieces of 1 x 1 angle iron cut to 4 inches in between the sprocket and drum as a jamming tool and you are all locked up without buying an expensive holding tool. 1) |
|
Clutch Sprocket Locking Tool 2) |
---|
This is the sprag I used to jam the clutch and engine sprockets to tighten the engine mainshaft nut (120 foot pounds). It has a divot cut out of it for the where the footpeg mount goes in a 77 model. It is right on 4“ long and made from about 1/4” flat strap. It is wide enough to fit on all three rows of the teeth on the sprocket. It is made from a piece of scrap metal so the countersunk hole is not necessary, just part of whatever it was before it became a special tool. It fits between the two sprockets to stop them from turning 3) |
||
Clutch Sprocket Locking Tool 4) |
---|
Hinge 5) |
5 Speed
A heavy duty 4“ door hinge works well. A cheap 4” door hinge bends like a pretzel. The derilin block just gets shredded up. But, the heavy duty 4“ hinge works great. 6) |
Home made sprocket lock 4.19” x 1.5“ x 5/16” steel with beveled edges 7) |
1)
bobber58 of the XLFORUM http://xlforum.net/forums/showthread.php?p=2828086&highlight=sprocket+lock#post2828086
3)
Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=2
4)
photos by Hopper of the XLFORUM http://xlforum.net/forums/showthread.php?t=395586&page=2
7)
photos by Hippysmack http://xlforum.net/forums/showthread.php?t=1848977