Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
techtalk:evo:carb01f [2019/10/17 15:41]
hippysmack [Repairing a Broken Enrichener Knob]
techtalk:evo:carb01f [2019/10/17 15:48]
hippysmack [Repairing a Broken Enrichener Knob]
Line 5: Line 5:
 The enrichener knob is plastic and can sometimes break. There is no set screw to remove it as it is molded onto the pull rod. \\ The enrichener knob is plastic and can sometimes break. There is no set screw to remove it as it is molded onto the pull rod. \\
 Several options can be had to replace the knob. It can be done without removing the carb from the bike. \\ Several options can be had to replace the knob. It can be done without removing the carb from the bike. \\
 +
 +You can go to your local home improvement store and purchase a nice looking chrome kitchen drawer pull knob. ((Simon of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=46782&​page=3)) \\
 +Enlarge the hole with a drill bit to rod and then glue it in place with epoxy. \\
 +
 +====== Mooneyes Knob ======
  
 This one was done with a "​Mooneyes"​ Deco Dash knob p/n SPC8425 $8.00. \\ This one was done with a "​Mooneyes"​ Deco Dash knob p/n SPC8425 $8.00. \\