Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:evo:carb01f [2019/10/17 15:44] hippysmack [Repairing a Broken Enrichener Knob] |
techtalk:evo:carb01f [2019/10/17 15:48] hippysmack [Repairing a Broken Enrichener Knob] |
||
---|---|---|---|
Line 5: | Line 5: | ||
The enrichener knob is plastic and can sometimes break. There is no set screw to remove it as it is molded onto the pull rod. \\ | The enrichener knob is plastic and can sometimes break. There is no set screw to remove it as it is molded onto the pull rod. \\ | ||
Several options can be had to replace the knob. It can be done without removing the carb from the bike. \\ | Several options can be had to replace the knob. It can be done without removing the carb from the bike. \\ | ||
+ | |||
+ | You can go to your local home improvement store and purchase a nice looking chrome kitchen drawer pull knob. ((Simon of the XLFORUM http://xlforum.net/forums/showthread.php?t=46782&page=3)) \\ | ||
+ | Enlarge the hole with a drill bit to rod and then glue it in place with epoxy. \\ | ||
====== Mooneyes Knob ====== | ====== Mooneyes Knob ====== |