Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:evo:carb03a [2019/04/09 20:04] hippysmack [Installing the Intake] |
techtalk:evo:carb03a [2019/04/09 20:09] hippysmack [Considerations] |
||
|---|---|---|---|
| Line 22: | Line 22: | ||
| The flanges are directional. There is a letter stamped on each flange for (F) - front or (R) - rear placement. \\ | The flanges are directional. There is a letter stamped on each flange for (F) - front or (R) - rear placement. \\ | ||
| There is a mounting hole on one side and a mounting slot on the other. \\ | There is a mounting hole on one side and a mounting slot on the other. \\ | ||
| - | The slot goes toward the 'tight side' between the cylinders or otherwise toward the left side of the bike. \\ | + | The slot goes toward the 'tight side' between the cylinders ((IXL2Relax of the XLFORUM http://xlforum.net/forums/showthread.php?t=2068828&highlight=intake+manifold&page=9)) or otherwise toward the left side of the bike. \\ |
| + | If you look at the flanges it should cause a bad mis-alignment if you use them the other way. ((rocketmangb of the XLFORUM http://xlforum.net/forums/showthread.php?t=2068828&highlight=intake+manifold&page=9)) \\ | ||
| |{{:techtalk:evo:carb:intake_manifold_flanges_2_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:carb:intake_manifold_flanges_1_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:evo:carb:intake_manifold_flanges_2_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:carb:intake_manifold_flanges_1_by_hippysmack.jpg?direct&300|}}| | ||
