Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:evo:carb03a [2019/04/09 20:38] hippysmack [Installing the Intake] |
techtalk:evo:carb03a [2019/08/28 22:38] hippysmack [Considerations] |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| ===== Considerations ===== | ===== Considerations ===== | ||
| + | **Repairing a Bend Where the Carb Mounts**: \\ | ||
| + | |{{:techtalk:evo:carb:bent_intake_manifold_fix_1_by_matt_black.jpg?direct&300|}}|{{:techtalk:evo:carb:bent_intake_manifold_fix_2_by_matt_black.jpg?direct&300|}}|{{:techtalk:evo:carb:bent_intake_manifold_fix_3_by_matt_black.jpg?direct&300|}}| | ||
| + | |||
| **Intake Mounting Bolts**: \\ | **Intake Mounting Bolts**: \\ | ||
| Inspect the intake mounting bolts for distortion at the threads as well as the Allen socket in the head. \\ | Inspect the intake mounting bolts for distortion at the threads as well as the Allen socket in the head. \\ | ||
| Line 64: | Line 67: | ||
| * Install the carb in the intake, the air cleaner on the carb and install the carb support on the heads loosely. | * Install the carb in the intake, the air cleaner on the carb and install the carb support on the heads loosely. | ||
| * Then wiggle the intake up/down and visually inspect the seal top to bottom for evenness. | * Then wiggle the intake up/down and visually inspect the seal top to bottom for evenness. | ||
| - | * Torque the crab support bolts. | + | * Torque the carb support bolts. |
| * Then torque the intake bolts. | * Then torque the intake bolts. | ||
| * Recheck the seal for evenness. | * Recheck the seal for evenness. | ||
