Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
techtalk:evo:elec03g [2021/08/22 05:30] ixl2relax [For 2014 - 2021 Models] |
techtalk:evo:elec03g [2021/08/22 05:33] (current) ixl2relax [For 1991 - 2013 Models] |
||
|---|---|---|---|
| Line 12: | Line 12: | ||
| Identify the two wires (BROWN wire for RIGHT-side & VIOLET wire for LEFT-side) that feed power to the lights. Find the two wires (WHITE/BROWN wire for RIGHT-side & WHITE/VIOLET wire for LEFT-side) that are incoming from the handlebar switches. | Identify the two wires (BROWN wire for RIGHT-side & VIOLET wire for LEFT-side) that feed power to the lights. Find the two wires (WHITE/BROWN wire for RIGHT-side & WHITE/VIOLET wire for LEFT-side) that are incoming from the handlebar switches. | ||
| - | The connector pin with incoming power is Pin2, Accessory Power, using an ORANGE wire or ORANGE/White or GREY wire. | + | The connector pin with incoming power is Pin2, Accessory Power, using an ORANGE wire or ORANGE/White or GREY wire. __**BE VERY CAREFUL HERE!**__ This power is fused but will allow many amps of power to flow before blowing. BE VERY CAREFUL not to short this pin to ground! |
| **BEING VERY CAREFUL** not to short any other pins:\\ | **BEING VERY CAREFUL** not to short any other pins:\\ | ||
| Line 38: | Line 38: | ||
| All the BCMs use the following pins for power to the TS lights:\\ | All the BCMs use the following pins for power to the TS lights:\\ | ||
| Front Right - PinJ2 - BLUE/Orange wire\\ | Front Right - PinJ2 - BLUE/Orange wire\\ | ||
| - | Front Left -- PinJ4 - BLUE/Pink wire\\ | + | Front Left --- PinJ4 - BLUE/Pink wire\\ |
| Rear Right -- PinK2 - BLUE/Brown wire\\ | Rear Right -- PinK2 - BLUE/Brown wire\\ | ||
| Rear Left --- PinK4 - BLUE/Violet wire\\ | Rear Left --- PinK4 - BLUE/Violet wire\\ | ||
| - | Pin1 has constant BATTERY POWER - **BE VERY CAREFUL HERE!** This power is fused thru the Main Fuse which will allow **40amps** of power to flow before blowing. **BE VERY CAREFUL** not to short this pin to ground! | + | Pin1 has constant BATTERY POWER - __**BE VERY CAREFUL HERE!**__ This power is fused thru the Main Fuse which will allow **40amps** of power to flow before blowing. **BE VERY CAREFUL** not to short this pin to ground! |
| With the TS module disconnected and the __KEYSWITCH OFF__, CAREFULLY put a jumper __BRIEFLY__ between Pin1 (Power into the module) and one of the above identified pins. As power is applied to each pin, the identified TS light should be lit. | With the TS module disconnected and the __KEYSWITCH OFF__, CAREFULLY put a jumper __BRIEFLY__ between Pin1 (Power into the module) and one of the above identified pins. As power is applied to each pin, the identified TS light should be lit. | ||
