Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:evo:engctl01 [2019/09/16 01:18] ixl2relax [IGNITION TIMING - All Models Thru 2003] |
techtalk:evo:engctl01 [2020/01/03 10:39] ixl2relax [2004-later Single-fire Spark Synchronization] |
||
|---|---|---|---|
| Line 66: | Line 66: | ||
| | 1998-2003 Exc 1200S | 32466-98B | ? | ???? | 32465-98B | ? | ???? | | | 1998-2003 Exc 1200S | 32466-98B | ? | ???? | 32465-98B | ? | ???? | | ||
| | 1998-2003 1200Sport Model |||| 32480-98A | ? | ???? | | | 1998-2003 1200Sport Model |||| 32480-98A | ? | ???? | | ||
| - | |||
| - | {{:techtalk:evo:engctl:camsensorplate-icm-98-03-a.jpg?450|}} | ||
| \\ | \\ | ||
| - | {{:techtalk:evo:engctl:ignitionsystem-dual-single.jpg?450|}} | + | {{:techtalk:evo:engctl:ignitionsystem-dual-single.jpg?450|}} {{:techtalk:evo:engctl:camsensorplate-icm-98-03-a.jpg?450|}} |
| \\ | \\ | ||
| Line 109: | Line 106: | ||
| \\ | \\ | ||
| - | ==== 2004-later Single-fire Spark Synchronization ==== | + | ==== Single-fire Spark Synchronization (2004-later) ==== |
| **ECM - Electronic Control Module**\\ | **ECM - Electronic Control Module**\\ | ||
| Line 553: | Line 550: | ||
| {{:techtalk:evo:engctl:camsensorplate.jpg?400|}} | {{:techtalk:evo:engctl:camsensorplate.jpg?400|}} | ||
| - | **Moving the Cam Sensor Plate Clockwise (CW) will increase the Advance Before TDC. Moving the plate Counterclockwise (CCW) will retard (or reduce) the Advance Before TDC. Note that each timing mark on the plate (long-to-short) is equal to changing the ignition timing by 5°. Move the plate __VERY LITTLE__ to make adjustments.** | + | **Moving the Cam Sensor Plate Clockwise (CW) will increase the Advance Before TDC. Moving the plate Counterclockwise (CCW) will retard (or reduce) the Advance Before TDC. Note that each timing mark on the plate (long-to-short) is equal to changing the ignition timing by 5°. Move the plate __VERY LITTLE__ to make adjustments.** ((aswracing post#17 at http://xlforum.net/forums/showthread.php?t=488663)) |
| The Cam Sensor Plate can be rotated slightly to accomodate getting the timing mark in the center of the timing hole. You can also move the plate to change the base timing (thus moving the whole curve sets up or down in rpm range) by setting the 1000rpm timing to a few degrees more or less than the specified (20° BTDC) advance timing mark. | The Cam Sensor Plate can be rotated slightly to accomodate getting the timing mark in the center of the timing hole. You can also move the plate to change the base timing (thus moving the whole curve sets up or down in rpm range) by setting the 1000rpm timing to a few degrees more or less than the specified (20° BTDC) advance timing mark. | ||
