Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:evo:engmech02b [2019/02/28 21:22] hippysmack [Test Fit the Lifters] |
techtalk:evo:engmech02b [2019/03/01 03:04] hippysmack [Considerations Before You Begin] |
||
|---|---|---|---|
| Line 32: | Line 32: | ||
| Notice how the left side of the pin touches the wall and the right side doesn't. \\ | Notice how the left side of the pin touches the wall and the right side doesn't. \\ | ||
| The pin diameter is split between the lifter bore and the pushrod tube drain. \\ | The pin diameter is split between the lifter bore and the pushrod tube drain. \\ | ||
| - | {{:techtalk:evo:engmech:91-99_lifter_pin_screw_upgrade_42_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) | + | |
| + | The pin sits just a few thousandths away from the lifter flat also. \\ | ||
| + | {{:techtalk:evo:engmech:91-99_lifter_pin_screw_upgrade_42_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:engmech:91-99_lifter_pin_screw_upgrade_52_by_hippysmack.jpg?direct&400|}} ((drawing by Hippysmack)) | ||
| Simplified drawings of the upgrade: \\ | Simplified drawings of the upgrade: \\ | ||
