Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:engmech02b [2019/02/28 23:08] hippysmack [Considerations Before You Begin] |
techtalk:evo:engmech02b [2019/11/14 04:50] hippysmack [Considerations Before You Begin] |
||
---|---|---|---|
Line 34: | Line 34: | ||
The pin sits just a few thousandths away from the lifter flat also. \\ | The pin sits just a few thousandths away from the lifter flat also. \\ | ||
- | {{:techtalk:evo:engmech:91-99_lifter_pin_screw_upgrade_42_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:engmech:91-99_lifter_pin_screw_upgrade_52_by_hippysmack.jpg?direct&400|}} ((drawing by Hippysmack)) | + | {{:techtalk:evo:engmech:91-99_lifter_pin_screw_upgrade_42_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:engmech:a91-99_lifter_pin_screw_upgrade_52_by_hippysmack.jpg?direct&400|}} ((drawing by Hippysmack)) |
Simplified drawings of the upgrade: \\ | Simplified drawings of the upgrade: \\ | ||
Line 43: | Line 43: | ||
The screw slid in the hole fine but it cinched up close to the lifter when tightened. \\ | The screw slid in the hole fine but it cinched up close to the lifter when tightened. \\ | ||
- | {{:techtalk:evo:engmech:91-99_lifter_pin_screw_upgrade_31_by_hippysmack.jpg?direct&400|}} {{:techtalk:evo:engmech:91-99_lifter_pin_screw_upgrade_32_by_hippysmack.jpg?direct&400|}} ((drawings by Hippysmack)) | + | {{:techtalk:evo:engmech:a91-99_lifter_pin_screw_upgrade_31_by_hippysmack.jpg?direct&400|}} {{:techtalk:evo:engmech:a91-99_lifter_pin_screw_upgrade_32_by_hippysmack.jpg?direct&400|}} ((drawings by Hippysmack)) |
+ | |||
+ | Factory tappet pin clearance on an 05 engine. \\ | ||
+ | {{:techtalk:evo:oil:05_tappet_screws_1_by_johnk.jpg?direct&300|}} ((photo by JohnK of the XLFORUM http://xlforum.net/forums/showthread.php?t=1422877&page=6)) | ||
+ | |||
Below is an example gone wrong using a scrap piece of aluminum. \\ | Below is an example gone wrong using a scrap piece of aluminum. \\ |