Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:evo:engmech04b [2019/01/28 23:53] hippysmack [Check the oiler hole in the exhaust rocker arm] |
techtalk:evo:engmech04b [2019/03/25 01:00] hippysmack [Rocker Arm Bushing Replacement] |
||
---|---|---|---|
Line 308: | Line 308: | ||
You can use a welding tip cleaner or other small wire to poke down this hole to clean or verify the hole is clear. \\ | You can use a welding tip cleaner or other small wire to poke down this hole to clean or verify the hole is clear. \\ | ||
- | {{:techtalk:evo:engmech:exhaust_rocker_arm_by_dirtycory.jpg?direct&300|}} ((photo by DirtyCory of the XLFORUM http://xlforum.net/forums/showpost.php?p=3945019&postcount=317)) {{:techtalk:evo:engmech:acleaning_oiler_hole_in_exhaust_rocker_arm_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | + | {{:techtalk:evo:engmech:exhaust_rocker_arm_by_dirtycory.jpg?direct&300|}} ((photo by DirtyCory of the XLFORUM http://xlforum.net/forums/showpost.php?p=3945019&postcount=317)) {{:techtalk:evo:engmech:cleaning_oiler_hole_in_rocker_arm_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ |
===== Visual Inpections ===== | ===== Visual Inpections ===== | ||
Line 324: | Line 324: | ||
**Note**: The bushing reamer (94804-57) has right hand blades. Always turn it to the right (clockwise) when installing, reaming or removing it from the bushings. \\ | **Note**: The bushing reamer (94804-57) has right hand blades. Always turn it to the right (clockwise) when installing, reaming or removing it from the bushings. \\ | ||
- | I would suggest to mic the bushings closely and several times to be sure you need to before replacing them. ((Hippysmack of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072192)) \\ | + | A helpful suggestion is to mic the bushings closely and several times to be sure you need to before replacing them. ((Hippysmack of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072192)) \\ |
If the rocker arm pads or the pushrod cups are worn badly, it'd probably be best to just replace the arms instead. \\ | If the rocker arm pads or the pushrod cups are worn badly, it'd probably be best to just replace the arms instead. \\ | ||
New rocker arms come with the bushings installed and sized. \\ | New rocker arms come with the bushings installed and sized. \\ |