Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:evo:engmech04b [2020/06/05 20:54] hippysmack [Clearancing the Rocker Boxes] |
techtalk:evo:engmech04b [2021/07/02 03:01] hippysmack [Check the shaft fit in the rocker cover] |
||
|---|---|---|---|
| Line 293: | Line 293: | ||
| * Per the specs in the FSM; \\ Shaft fit in rocker cover (loose) \\ New Install .0007” - .0022“ (.018 mm - .056 mm) \\ Wear Limits .0035” (.089 mm) \\ There was not enough clearance on one side (as the dims show in the pic below). \\ | * Per the specs in the FSM; \\ Shaft fit in rocker cover (loose) \\ New Install .0007” - .0022“ (.018 mm - .056 mm) \\ Wear Limits .0035” (.089 mm) \\ There was not enough clearance on one side (as the dims show in the pic below). \\ | ||
| - | |{{:techtalk:evo:oil:inspecting_rocker_box_shaft_bore_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:oil:inspecting_rocker_box_shaft_bore_2_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:engmech:inspecting_rocker_box_shaft_bore_7.2_by_hippysmack.jpg?direct&300|}}| | + | |{{:techtalk:evo:oil:inspecting_rocker_box_shaft_bore_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:oil:inspecting_rocker_box_shaft_bore_2_by_hippysmack.jpg?direct&300|}}|{{:techtalk:evo:engmech:AAAinspecting_rocker_box_shaft_bore_7.2_by_hippysmack.jpg?direct&300|}}| |
| * The Jims reamer (94804-57) was used to run through the loose side to square up the hole for reaming on the other. \\ A 12-point 12 mm socket was used as a finger hold to turn the reamer in by hand. \\ (turning slowly by hand to let the reamer do the cutting) | * The Jims reamer (94804-57) was used to run through the loose side to square up the hole for reaming on the other. \\ A 12-point 12 mm socket was used as a finger hold to turn the reamer in by hand. \\ (turning slowly by hand to let the reamer do the cutting) | ||
