Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:evo:susp03a [2020/06/13 07:15] hippysmack [Removing Bearings and Races] |
techtalk:evo:susp03a [2020/06/13 07:28] hippysmack [Removing Bearing Races] |
||
|---|---|---|---|
| Line 89: | Line 89: | ||
| {{:techtalk:evo:susp:swingarm_maintenance_37_by_hippysmack.jpg?direct&300|}} \\ | {{:techtalk:evo:susp:swingarm_maintenance_37_by_hippysmack.jpg?direct&300|}} \\ | ||
| + | ====== Removing Pivot Spacer Bushing ====== | ||
| + | The FSM says to replace this bushing only if needed. \\ | ||
| + | However, there is no criteria / spec to determine if it's needed. \\ | ||
| + | The bushing is pressed in and likewise will have to be pressed out. They make a special tool for removing / installing the bushing. \\ | ||
| + | The rig below can also be used as a remover / installer tool. \\ | ||
| + | {{:techtalk:evo:susp:swingarm_bushing_remover-installer_1_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
| + | |||
| + | {{:techtalk:evo:susp:swingarm_bushing_remover-installer_2_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:susp:swingarm_bushing_remover-installer_3_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:susp:swingarm_bushing_remover-installer_4_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
| + | |||
| + | {{:techtalk:evo:susp:swingarm_bushing_remover-installer_5_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:susp:swingarm_bushing_remover-installer_6_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) {{:techtalk:evo:susp:swingarm_bushing_remover-installer_7_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
