Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
techtalk:evo:susp03a [2020/06/16 23:13] hippysmack [Bearing Outer Races] |
techtalk:evo:susp03a [2020/06/17 02:25] hippysmack [Inspecting the Swingarm and Parts] |
||
---|---|---|---|
Line 46: | Line 46: | ||
Check that the swingarm isn't warped, damaged or rusted. \\ | Check that the swingarm isn't warped, damaged or rusted. \\ | ||
+ | |||
+ | {{:techtalk:evo:susp:swingarm_maintenance_36_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
+ | |||
Remove the pivot bolt spacer and inspect both the spacer and it's bushing in the left pivot for damage or pitting. \\ | Remove the pivot bolt spacer and inspect both the spacer and it's bushing in the left pivot for damage or pitting. \\ | ||
Line 112: | Line 115: | ||
The best tools ended up being a flat aluminum scrap piece and a hammer to 'set' the races in straight and a threaded rod and socket press to pull the races home. \\ | The best tools ended up being a flat aluminum scrap piece and a hammer to 'set' the races in straight and a threaded rod and socket press to pull the races home. \\ | ||
Just slight tapping was all that was required to get them started. \\ | Just slight tapping was all that was required to get them started. \\ | ||
+ | |||
+ | The races will have a certain resistance when pressing them in. You'll feel the resistance and the races moving. \\ | ||
+ | If the resistance changes drastically (tightens suddenly), STOP, remove the tool and find out why. \\ | ||
{{:techtalk:ref:tools:swingarm_bearing_race_installation_6_by_hippysmack.jpg?direct&300|}} {{:techtalk:ref:tools:swingarm_bearing_race_installation_7_by_hippysmack.jpg?direct&300|}} \\ | {{:techtalk:ref:tools:swingarm_bearing_race_installation_6_by_hippysmack.jpg?direct&300|}} {{:techtalk:ref:tools:swingarm_bearing_race_installation_7_by_hippysmack.jpg?direct&300|}} \\ |