Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
techtalk:evo:susp03a [2020/06/16 23:18] hippysmack [Installation] |
techtalk:evo:susp03a [2020/06/17 02:32] hippysmack [Inspecting the Swingarm and Parts] |
||
---|---|---|---|
Line 46: | Line 46: | ||
Check that the swingarm isn't warped, damaged or rusted. \\ | Check that the swingarm isn't warped, damaged or rusted. \\ | ||
+ | |||
+ | {{:techtalk:evo:susp:swingarm_maintenance_36_by_hippysmack.jpg?direct&300|}} ((photo by Hippysmack)) \\ | ||
+ | |||
Remove the pivot bolt spacer and inspect both the spacer and it's bushing in the left pivot for damage or pitting. \\ | Remove the pivot bolt spacer and inspect both the spacer and it's bushing in the left pivot for damage or pitting. \\ | ||
Line 56: | Line 59: | ||
Hopefully your bearings won't look as bad as the ones below. You can spray them down with brake cleaner to clean off the old grease. \\ | Hopefully your bearings won't look as bad as the ones below. You can spray them down with brake cleaner to clean off the old grease. \\ | ||
- | After cleanup, these bearings sis not roll smooth (bumps felt while turning) so they had to be replaced. \\ | + | After cleanup, these bearings did not roll smooth (bumps felt while turning) so they had to be replaced. \\ |
{{:techtalk:evo:susp:swingarm_maintenance_19_by_hippysmack.jpg?direct&300|}} {{:techtalk:evo:susp:swingarm_maintenance_20_by_hippysmack.jpg?direct&300|}} | {{:techtalk:evo:susp:swingarm_maintenance_19_by_hippysmack.jpg?direct&300|}} {{:techtalk:evo:susp:swingarm_maintenance_20_by_hippysmack.jpg?direct&300|}} |